Wireless surveillance equipment is considerably less difficult to mount than its wired counterparts. All you should have is a strong Wi-Fi connection to replace messy wires, drilled walls and hours (even days) of challenging work. The issue with a wireless security system, though, is that it is vulnerable to network slowdowns that make it harder - sometimes even not possible - to get a bright real-time video feed of what is going on.
So without further ado, here are a few top guidelines to help increase the speed and reliability of your wireless security network:
1. Decrease the obstructions amongst the camera and the DVR One of the most apparent factors that halt wireless surveillance equipment is physical obstructions. Your wireless surveillance equipment network must ideally have a clear line of sight to the wireless receivers. This might not be feasible for all networks though, especially for ones with cameras spread out across various areas. Do note that supplies like wood and plaster do not block wireless signals as fully as bricks, concrete or metal. If you have a selection amongst putting a wireless camera or a Wi-Fi router behind a wooden wall or a concrete wall, decide on the former to decrease the obstructing effect on wireless signals.
2. Match your video settings to match the obtainable bandwidth. A wireless safety camera can also slow down its video feed if the Wi-Fi connection does not have the bandwidth to deal with the load at first. Basically put, you mustn't often pick the best quality video settings just since your surveillance equipment can do so. High video capture resolutions, high frame rates and a number of cameras on a safety system can put critical strains on the bandwidth capacities of a router. Over stressing the network could result in faulty video feeds that are distorted or even cut off. This is especially true when your wireless top leading surveillance equipment upload their captured info to the Internet. If a Wi-Fi router has enough trouble handling multiple high-res video feeds on a regional connection, then you can bet that it'll have even much more troubles handling a feed that it has to stream over the Internet.
3. Pick a low-traffic wireless channel. Other wireless models like phones, tablets and smart TVs can conflict with the connections of your wireless surveillance system. This approach sounds technical at first glance but there are thankfully programs out there that can simplify the process for you.
Firstly you will need network analyzer application like inSSIDer. Download this program or an equivalent system and install it on your personal computer. Run the system and pick the alternative where it will scan 2.4 GHz channels. You must come up with a graph displaying you which channel has the highest signal strength, ergo the one that is least choked by other wireless models. Take note of this channel as you open up the control panel window of the router connected to your wireless surveillance network. Log in and pick the channel you noted earlier to fulfill the process.
Keep all these in mind and your wireless surveillance equipment will run smoother and come across fewer difficulties in the long run!
No comments:
Post a Comment